Quick answer
OSHA 10 construction training focuses on the Focus Four hazards: falls, struck-by, caught-in or between, and electrocution. Key numbers: fall protection at 6 feet, trench protection at 5 feet, ladders 3 feet above the landing, report fatalities within 8 hours. OSHA 10 cards come only from authorized trainers.
Practice only. Not an official test.
These are original practice questions written by PITHE Digital Group for study purposes, based on public laws, codes and agency guidance. They are not real or past exam questions, and this page is not affiliated with, endorsed by or sponsored by OSHA, Oregon OSHA, Washington L&I or any authorized OSHA Outreach trainer or any testing company. A score here does not predict your real exam result and does not give you any license, permit, card or certificate.
Laws, codes and fees change, and mistakes are possible. Always confirm with the official agency and your approved course materials. This is general educational information, not legal or professional advice. Read the full disclaimer.
Exam facts are from public agency sources as of November 7, 2026. Confirm current details with the official agency before you schedule.
Whether you are taking an OSHA 10 class, training a new crew or just want a safer job site, these questions cover the Focus Four hazards and the rules contractors get cited for most. Oregon and Washington run their own state safety plans, so we point out where to check local rules.
How it works: tap an answer to see if you got it right, why, and the law or code it comes from. Your progress saves on this device only, so you can bookmark the page and pick up later. No signup, no card.
Jump to: Falls · Struck-by and caught-in · Electrical · Health hazards · Rights and recordkeeping
Falls
Practice question 1 · Falls
What are OSHA's "Focus Four" construction hazards?
Answer: C. Falls, struck-by, caught-in or between, and electrocution These four cause most construction deaths.Source: OSHA Construction Focus Four training
Practice question 2 · Falls
At what height does federal OSHA generally require fall protection in construction?
Answer: A. 6 feet Fall protection is required at 6 feet or more above a lower level. Oregon OSHA and Washington L&I run state plans, so check their rules too.Source: 29 CFR 1926.501(b)(1)
Practice question 3 · Falls
What is the height of a guardrail's top rail?
Answer: D. 42 inches, plus or minus 3 inches Top rails are 42 inches (plus or minus 3) above the walking surface.Source: 29 CFR 1926.502(b)(1)
Practice question 4 · Falls
How much force must a top rail withstand?
Answer: A. 200 pounds Top rails must withstand at least 200 pounds applied outward or downward.Source: 29 CFR 1926.502(b)(3)
Practice question 5 · Falls
How must a hole cover be marked?
Answer: A. With the word "HOLE" or "COVER" Covers must be secured and marked "HOLE" or "COVER."Source: 29 CFR 1926.502(i)(4)
Practice question 6 · Falls
What is the correct angle for an extension ladder?
Answer: D. 1 foot out for every 4 feet up The 4-to-1 rule: base 1 foot from the wall for every 4 feet of working length.Source: 29 CFR 1926.1053(b)(5)(i)
Practice question 7 · Falls
How far above the landing must an extension ladder extend?
Answer: A. 3 feet Side rails extend at least 3 feet above the landing.Source: 29 CFR 1926.1053(b)(1)
Practice question 8 · Falls
Can you stand on the top cap of a stepladder?
Answer: A. No The top and top step of a stepladder are not to be used as a step.Source: 29 CFR 1926.1053(b)(13)
Practice question 9 · Falls
Who must inspect scaffolds before each shift?
Answer: B. A competent person A competent person inspects scaffolds before each shift and after anything that could affect them.Source: 29 CFR 1926.451(f)(3)
Struck-by and caught-in
Practice question 10 · Struck-by and caught-in
At what trench depth is a protective system generally required?
Answer: D. 5 feet Five feet or deeper needs sloping, shoring or a shield, unless in stable rock.Source: 29 CFR 1926.652(a)
Practice question 11 · Struck-by and caught-in
Trenches deeper than how many feet need a protective system designed by a registered professional engineer?
Answer: A. 20 feet Over 20 feet deep, a registered professional engineer must design the protective system.Source: 29 CFR 1926.652(b) and (c)
Practice question 12 · Struck-by and caught-in
How close must a ladder or other way out be in trenches 4 feet or deeper?
Answer: D. Within 25 feet of lateral travel Workers must have a ladder, stairway or ramp within 25 feet.Source: 29 CFR 1926.651(c)(2)
Practice question 13 · Struck-by and caught-in
How far back from a trench edge must spoil piles be kept?
Answer: A. At least 2 feet Keep spoils and equipment at least 2 feet from the edge.Source: 29 CFR 1926.651(j)(2)
Practice question 14 · Struck-by and caught-in
What reduces struck-by hazards from vehicles on site?
Answer: B. High-visibility clothing, spotters and backup alarms Be seen, stay out of blind spots and use spotters.Source: OSHA Struck-By hazards training
Practice question 15 · Struck-by and caught-in
What is lockout/tagout?
Answer: A. Shutting off and locking energy sources so machines cannot start while being serviced LOTO prevents unexpected startup or release of stored energy.Source: 29 CFR 1910.147
Electrical
Practice question 16 · Electrical
What is the minimum distance to keep from overhead power lines up to 50 kV?
Answer: D. 10 feet Stay at least 10 feet away from lines up to 50 kV, more for higher voltages. Assume all lines are energized.Source: 29 CFR 1926.416 and 1926.1408
Practice question 17 · Electrical
What protects workers using extension cords and tools on construction sites?
Answer: B. GFCIs or an assured equipment grounding conductor program Ground-fault protection shuts off power before a shock becomes deadly.Source: 29 CFR 1926.404(b)(1)
Practice question 18 · Electrical
A cord has a cut in the outer jacket. What should you do?
Answer: D. Remove it from service Damaged cords must be removed from service until repaired or replaced.Source: 29 CFR 1926.416(e)
Health hazards
Practice question 19 · Health hazards
What do Safety Data Sheets (SDS) provide?
Answer: B. Hazard, protection and first aid information for chemicals SDS follow a standard 16-section format.Source: 29 CFR 1910.1200(g)
Practice question 20 · Health hazards
How many sections are on a standard Safety Data Sheet?
Answer: D. 16 Section 1 is identification, Section 2 hazards, and so on through 16.Source: 29 CFR 1910.1200 Appendix D
Practice question 21 · Health hazards
At what 8-hour average noise level must employers start a hearing conservation program?
Answer: B. 85 dBA The action level is 85 dBA. The permissible exposure limit is 90 dBA.Source: 29 CFR 1910.95
Practice question 22 · Health hazards
Cutting concrete creates what serious hazard?
Answer: A. Respirable crystalline silica dust Silica causes lung disease. Use water, vacuums and respirators as OSHA's Table 1 describes.Source: 29 CFR 1926.1153
Practice question 23 · Health hazards
In Oregon, at what heat index must employers follow heat illness prevention rules?
Answer: C. 80 degrees F Oregon OSHA heat rules apply when the heat index is 80 degrees F or higher: shade, water, rest and a plan.Source: Oregon OSHA heat illness prevention rule, OAR 437-002-0156
Practice question 24 · Health hazards
What is the maximum travel distance to a fire extinguisher on a construction site?
Answer: D. 100 feet A fire extinguisher rated 2A or more is required within 100 feet of travel.Source: 29 CFR 1926.150(c)(1)(i)
Rights and recordkeeping
Practice question 25 · Rights and recordkeeping
How soon must an employer report a work-related fatality to OSHA?
Answer: B. Within 8 hours Fatalities are reported within 8 hours. In-patient hospitalization, amputation or loss of an eye within 24 hours.Source: 29 CFR 1904.39
Practice question 26 · Rights and recordkeeping
How soon must an employer report a work-related amputation?
Answer: A. Within 24 hours Amputations, hospitalizations and eye losses are reported within 24 hours.Source: 29 CFR 1904.39
Practice question 27 · Rights and recordkeeping
Can an employer punish a worker for reporting a safety concern?
Answer: B. No, that is illegal retaliation Workers are protected from retaliation for safety complaints. Federal complaints generally must be filed within 30 days.Source: OSH Act Section 11(c)
Practice question 28 · Rights and recordkeeping
In what language must safety training be given?
Answer: C. In a language and vocabulary workers understand Training only counts if workers understand it.Source: OSHA training standards policy
Practice question 29 · Rights and recordkeeping
Who runs the workplace safety program in Oregon and Washington?
Answer: D. State plans: Oregon OSHA and Washington L&I (DOSH) Both states run approved state plans with rules at least as effective as federal OSHA, and sometimes stricter.Source: OSHA State Plans
Practice question 30 · Rights and recordkeeping
What is the OSHA 300 log used for?
Answer: D. Recording work-related injuries and illnesses Many employers must record injuries and post the yearly summary (Form 300A) from February 1 to April 30.Source: 29 CFR 1904
Practice score only. This is not an official result and does not predict how you will do on the real exam.
Running a crew? Safe, organized contractors earn better reviews. We list contractors free and build websites that show off your work.
How to pass: study tips that work
- Learn the Focus Four and one prevention method for each.
- Memorize the trigger numbers: 6 ft falls, 5 ft trenches, 20 ft engineered design, 25 ft ladder access, 10 ft from power lines.
- Know worker rights and how to report hazards.
- Check Oregon OSHA or Washington L&I for state rules.
Official sources to study from
Use the official materials and approved courses as your real guide. These links go to the agencies, not to us.
See a mistake or an outdated rule? Tell us and we will check it against the official source and fix it.
More free practice tests
Common questions
Does this give me an OSHA 10 card?
No. OSHA 10 cards come only from authorized trainers. This is free practice.
Does Oregon follow federal OSHA?
Oregon runs its own approved state plan, Oregon OSHA, with rules at least as effective as federal OSHA. Washington's plan is run by L&I's DOSH.
Are these real OSHA construction safety exam questions?
No. They are original practice questions written by PITHE Digital Group from public laws, codes and agency guidance. They are not real or past exam questions, and we are not affiliated with OSHA, Oregon OSHA, Washington L&I or any authorized OSHA Outreach trainer or any testing company.
Does passing this OSHA construction safety practice test give me a license or certificate?
No. This free practice test is for study only. You must complete the official requirements and pass the official exam through the agency or its approved provider.
Is this practice test free?
Yes. It is free with no signup. Your progress saves only on your device.
Save this page. Bookmark it (on iPhone tap Share, then Add Bookmark) or send it to someone starting out.
Want customers to find you, too?
List your business free, or get a free website mockup and a written quote from our Pacific Northwest team.