Quick answer
OSHA requires employers to train and evaluate forklift operators, with a performance evaluation at least every 3 years. Operators must inspect trucks before each shift, never exceed the data plate capacity, keep loads low and tilted back, keep loads uphill on ramps, and stay in the seat if a truck tips.
Practice only. Not an official test.
These are original practice questions written by PITHE Digital Group for study purposes, based on public laws, codes and agency guidance. They are not real or past exam questions, and this page is not affiliated with, endorsed by or sponsored by OSHA, Oregon OSHA, Washington L&I or any forklift manufacturer or trainer or any testing company. A score here does not predict your real exam result and does not give you any license, permit, card or certificate.
Laws, codes and fees change, and mistakes are possible. Always confirm with the official agency and your approved course materials. This is general educational information, not legal or professional advice. Read the full disclaimer.
Exam facts are from public agency sources as of November 7, 2026. Confirm current details with the official agency before you schedule.
Warehouses, lumber yards and contractors all need trained operators. Use this to study or to quiz new hires before hands-on training.
How it works: tap an answer to see if you got it right, why, and the law or code it comes from. Your progress saves on this device only, so you can bookmark the page and pick up later. No signup, no card.
Jump to: Operator rules · Stability and loads · Workplace safety
Operator rules
Practice question 1 · Operator rules
How often must a forklift operator's performance be evaluated under OSHA?
Answer: B. At least once every 3 years Employers must evaluate each operator at least every three years, and give refresher training after accidents, near misses or unsafe operation.Source: 29 CFR 1910.178(l)(4)
Practice question 2 · Operator rules
Who must train and certify forklift operators?
Answer: D. The employer, using people with the knowledge and experience to train Employers certify that operators were trained and evaluated.Source: 29 CFR 1910.178(l)
Practice question 3 · Operator rules
Under federal child labor rules, what is the minimum age to operate a forklift in most non-farm jobs?
Answer: D. 18 Hazardous Occupations Order No. 7 bars workers under 18 from operating forklifts in most non-agricultural jobs.Source: U.S. Department of Labor, Hazardous Occupations Order No. 7
Practice question 4 · Operator rules
Can an untrained worker drive the forklift "just for a minute"?
Answer: C. No, only trained and authorized operators may operate it Only trained, evaluated and authorized operators may run a powered industrial truck.Source: 29 CFR 1910.178(l)(1)
Practice question 5 · Operator rules
When should a forklift be inspected?
Answer: A. Before each shift (daily), and removed from service if it is unsafe Check brakes, steering, horn, forks, chains, tires, fluids and safety devices before use.Source: 29 CFR 1910.178(q)(7)
Stability and loads
Practice question 6 · Stability and loads
Where do you find a forklift's rated capacity?
Answer: C. On the data (capacity) plate Never exceed the capacity shown on the data plate for the load center listed.Source: 29 CFR 1910.178(a)(6); manufacturer data plates
Practice question 7 · Stability and loads
What is the "stability triangle"?
Answer: C. The area formed by the front wheels and the rear axle pivot where the combined center of gravity must stay If the center of gravity moves outside the triangle, the truck can tip.Source: OSHA Powered Industrial Trucks eTool
Practice question 8 · Stability and loads
What is the most common load center used on capacity plates?
Answer: C. 24 inches Many forklifts are rated at a 24-inch load center. Longer loads reduce safe capacity.Source: OSHA Powered Industrial Trucks eTool
Practice question 9 · Stability and loads
How high should forks be when traveling?
Answer: D. Low, a few inches off the ground and tilted back Keep the load low and tilted back for stability and visibility.Source: OSHA Powered Industrial Trucks eTool
Practice question 10 · Stability and loads
When driving a loaded forklift on a ramp, which way should the load face?
Answer: B. Uphill With a load, keep it upgrade both going up and coming down.Source: 29 CFR 1910.178(n)(7)
Practice question 11 · Stability and loads
What should an operator do if the forklift starts to tip over?
Answer: D. Stay in the seat, hold on, brace your feet and lean away from the tip Jumping is how operators get crushed. Wear the seat belt and stay inside.Source: OSHA Powered Industrial Trucks eTool
Workplace safety
Practice question 12 · Workplace safety
What should an operator do at blind corners and intersections?
Answer: C. Slow down and sound the horn Pedestrians cannot always see or hear a forklift coming.Source: 29 CFR 1910.178(n)(4)
Practice question 13 · Workplace safety
May anyone ride on the forks?
Answer: C. No, no riders unless a safe place is provided by the manufacturer Never let anyone ride on the forks or stand under a raised load.Source: 29 CFR 1910.178(m)(3)
Practice question 14 · Workplace safety
What hazard is created when charging lead-acid forklift batteries?
Answer: A. Hydrogen gas buildup, which can explode Charge in ventilated areas, no smoking or sparks, and wear eye protection when handling electrolyte.Source: 29 CFR 1910.178(g)
Practice question 15 · Workplace safety
What should you do when leaving a forklift unattended?
Answer: B. Lower the forks fully, neutralize controls, shut it off and set the brake An unattended truck must be secured so it cannot move or drop a load.Source: 29 CFR 1910.178(m)(5)
Practice score only. This is not an official result and does not predict how you will do on the real exam.
Running a warehouse, supply or equipment business? We list businesses free.
How to pass: study tips that work
- Learn the stability triangle and load center.
- Know the inspection checklist.
- Remember: practice tests do not replace hands-on evaluation.
Official sources to study from
Use the official materials and approved courses as your real guide. These links go to the agencies, not to us.
See a mistake or an outdated rule? Tell us and we will check it against the official source and fix it.
More free practice tests
Common questions
Is this a forklift certification?
No. Employers must train, evaluate and certify operators with hands-on evaluation.
Are these real Forklift operator exam questions?
No. They are original practice questions written by PITHE Digital Group from public laws, codes and agency guidance. They are not real or past exam questions, and we are not affiliated with OSHA, Oregon OSHA, Washington L&I or any forklift manufacturer or trainer or any testing company.
Does passing this Forklift operator practice test give me a license or certificate?
No. This free practice test is for study only. You must complete the official requirements and pass the official exam through the agency or its approved provider.
Is this practice test free?
Yes. It is free with no signup. Your progress saves only on your device.
Save this page. Bookmark it (on iPhone tap Share, then Add Bookmark) or send it to someone starting out.
Want customers to find you, too?
List your business free, or get a free website mockup and a written quote from our Pacific Northwest team.